legacycentral bbs

I removed the drivers side auto belt and put a manual belt on the drivers side only. How do I ground the seat belt warning light so it won't keep flashing on my dash board. I want my passenger side auto belt to still work so I don't want to disconnect the auto belt controller in the back of the wagon unless you can just disconnect one side of the auto belt only?
I have no idea what connector to ground/jump or how to go about doing that.
Thanks for any help

Pull the bulb...

I figured it out. I just went threw the auto belt computer and pulled the wires needed to cut the seat belt warning light but not the passenger side seat belt motor