Page 1 of 1
clutch resivoir
Posted: Thu Jul 31, 2008 3:00 pm
by lucas
i heard of a few of you guys cutting your clutch resivoirs to make an intercooler fit. My question is how and where did you cut it? form the top or bottom?
cut bottom
Posted: Thu Jul 31, 2008 4:26 pm
by kleinkid
You would need to cut the bottom, so you can still latch the cap on.
Posted: Thu Jul 31, 2008 4:54 pm
by Dynamic Entry
ya, bottom cut for sure
pump out fluid, take off, hacksaw about an inch off, put back on, new fluid, voila
make sure you have a smooth cut and don't leave any shards inside
Posted: Thu Jul 31, 2008 4:55 pm
by dscoobydoo
Why cut when you can go to a junkyard and get the smaller/right side off-set one that FITS WITHOUT CUTTING!