Page 1 of 1
Axle compatibility
Posted: Thu Sep 11, 2008 2:19 am
by rmarques
Hey all I'm new here - just bought a 92 SS.
I'm wanting to know if the axles from a 00 Impreza RS are compatible with the Legacy trans and knuckles.
And FYI yes I am too lazy (busy) to spend my time searching!
Thanks.
Posted: Thu Sep 11, 2008 6:24 am
by altron23
front or rear? auto or manual?
they should work on the front, but in the rear your ss should have stub shafts coming out of the diff i do belive? look at the rear diff axles and see if there are roll pins holding the axle on the stub shaft.
if not shure you could go by your nearest subaru dealer and ask the parts department the same Q.
Posted: Thu Sep 11, 2008 6:17 pm
by rmarques
Yeah good point, the WRX(3.9) axles don't have roll pins and the RS(4.11) ones do.
And 5spd RF corner. I have yet to put it in the air but I will post back with my findings for future reference.
Thanks.
Posted: Thu Sep 18, 2008 3:15 am
by rmarques
Took a quick look and the car has pins front and back. I haven't replaced any axles though.. diag'd the noise to something else.