Page 1 of 1
WTB: AWIC Heat Exchanger
Posted: Sat Oct 04, 2008 3:10 pm
by drewriviera
I need to buy a factory Subaru heat exchanger for the AWIC setup...the one I have now requires me to cut my bumper and I don't want to do that. Any help would be appreciated.
Thanks
-Andrew
drewriviera@yahoo.com
Posted: Thu Oct 09, 2008 7:59 pm
by farfrumwork
Sorry, I don't have what you're looking for but have you looked into the Mustang Cobra stock heat exchangers?
They are long and fairly narrow. I was looking into some of the aftermarket cobra units, and by the measurements I found I think the stock exchanger would fit in the lower section of the SS bumper. They are fairly cheap too.
I am not sure what brand exchangers i have for my AWIC setup, but they are 1" deep so they fit behind the bumper beam. I run 2 in series, and they are about 10"x8" (or so, I can't remember off the top of my head). Mine are appear to be very nice, with a ton of fins per inch (technical description I know
) - Again, I haven't been able to determine
what they are though....
Good luck!