legacycentral bbs

As we all know, the knock sensor wire is pretty brittle. Well Does anyone think that a non turbo wire work too? i came across the whole wire plug included on both sides (other end ecu plug.)
I was going to go ahead a put it in and see if that would solve my problems but decided to run it by everyone for an opinion first before i possibly "waste my time"

Anyways, i look forward to your opinions.

The knock sensors are the same - same part number between turbo and non. It should work fine.

Although if you are going to the trouble why use a used component? Do it right with some new shielded com cable.

GD

where would i find sheilded com wire?

Well i swapped out my Knock sensor wire today, and i'm glad i did. No more CE Light so i would "assume" it works. now i only have 3 other sets of wire to replace. stupid old wires.