Page 1 of 1
Autronic cal file
Posted: Fri Nov 14, 2008 1:50 pm
by DARTHVADER
Anybody with Autronic SMC want to share their cal file?
Also need manual for SMC PnP-what to set jumpers to, which two maf wires to splice into for the Autronic temp sensor, ect.
Autronic help
Posted: Fri Nov 14, 2008 8:52 pm
by kleinkid
I am using the Autronic SMC. Dustin at Surgeline Tuning(Portland, Ore.), formerly PDX Tuning, installed it, and Mick Posner(Mick_the_ginge) tuned the car for me. Mick is very familiar with Autronic, and Dustin is the Autronic dealer at Surgeline Tuning. I would give them a call, I'm sure they would be very helpful. You may have seen this website, but if you have not, this is a good place for info also.
http://www.mrm-racing.se/forum/index.php
Posted: Fri Nov 14, 2008 8:58 pm
by Legacy777
John,
When did PDX change their name?
Posted: Fri Nov 14, 2008 9:21 pm
by kleinkid
Ownership changed hands in August. Tim Bailey is at least the general manager, I believe he has an ownership interest also. Dustin Harris remains as the lead mechanic, great decision in my opinion. So yeah, they have the Mustang dyno and are a Cobb dealer.
Re: Autronic help
Posted: Mon Nov 17, 2008 6:11 pm
by DARTHVADER
kleinkid wrote:I am using the Autronic SMC. Dustin at Surgeline Tuning(Portland, Ore.), formerly PDX Tuning, installed it, and Mick Posner(Mick_the_ginge) tuned the car for me. Mick is very familiar with Autronic, and Dustin is the Autronic dealer at Surgeline Tuning. I would give them a call, I'm sure they would be very helpful. You may have seen this website, but if you have not, this is a good place for info also.
http://www.mrm-racing.se/forum/index.php
Yep nobody willing to help with stock cal file their.
Also tried way back machine for access to ray halls old site found all the custom software and a few cal files but attempting to down load produces not found pages.....
Can't come with in 200ft of them since they changed ownership... enough said!