legacycentral bbs

I've decided to use a TD04 setup with my IC. I measured the turbo's inlet and its 2 1/8 exactly. Now for a silicone inlet I plan to use a 90 degree reducer from siliconeintakes.com Do I get a 2 inch, and squeeze it on? Or do I get a 2 1/4 and cramp it on? Since they have no 2 1/8. Also what is the ID of the stock rubber 90 degree inlet goin into the VF11?

Thanks

I got 2 1/4 and it fits nice.

IIRC I used a 2-1/4" x 2" elbow and cut it so that it would not be squished against the manifold.

Double-check your TD-04 inlet O.D. and stock plastic 90* I.D.