legacycentral bbs

Posted: **Thu Jan 08, 2009 6:36 am**

is it ok to buy after market headers for a non turbo car. i am assuming they make headers for the N/A as well, but would there be any reason and would help along with a cat back exhaust

Posted: **Thu Jan 08, 2009 7:00 am**

I wish someone made a cheap N/A header for the 2.2L. You can buy decent quality stainless headers for a honda civic for under a $150. None to be found that cheap for a Subie..

Posted: **Thu Jan 08, 2009 7:09 am**

Unfortunately, not many people are in the game of hotrodding their N/A subarus. Just not enough demand.

If you went to a newer style exhaust, you could get the borla knock-offs on ebay for fairly cheap.

Posted: **Thu Jan 08, 2009 1:55 pm**

They'd be more than a Civic anyway—2 heads, longer pipes.

Posted: **Thu Jan 08, 2009 2:32 pm**

i have seen them for like 250 and i dont think i mind paying just wondering since they would be for a 2.5 L would i get any gain from using them. plus i would be getting an exhaust to go with it

Posted: **Sat Jun 27, 2009 9:37 am**

Buffman wrote:I wish someone made a cheap N/A header for the 2.2L. You can buy decent quality stainless headers for a honda civic for under a $150. None to be found that cheap for a Subie..

There is a guy selling them for the 2.2L single port heads at rs25.com, here's a link:

http://www.rs25.com/forums/f14/t107933- ... stock.html

Posted: **Sat Jun 27, 2009 2:39 pm**

Single port headers won't work on our cars. We have the dual port exhaust heads.

Posted: **Thu Jul 16, 2009 10:51 pm**

Legacy777 wrote:Single port headers won't work on our cars. We have the dual port exhaust heads.

Unless it's a 96 and up ej22e Legacy

Posted: **Fri Jul 17, 2009 3:39 am**

Which case there are a few options also. I have a set for my 98 EJ22E that are single-port which I'm having installed tomorrow. MS3 sells them on RS25. A bit pricey, but they're stainless and look pretty good.

Posted: **Fri Jul 17, 2009 7:29 pm**

If you're looking for a set of dual port EL headers, check out OBX. I think it's around $250 for a set. Cheapish, but not dirt cheap.

I bought some, still sitting in the garage waiting a head/motor swap into the OBW and then they'll get installed.

Pretty nice quality, S/S, decent welds. Overall I've been very happy with them for not having them installed yet.

Posted: **Mon Jul 20, 2009 6:45 am**

so dual port is what i need for my N/A, ill have to check out OBX

Posted: **Mon Jul 20, 2009 9:27 pm**

Yes, any pre-95 EJ22E should be dual-port.

Interested in equal-length?

legacycentral bbs

headers on N/A car

headers on N/A car