Page 1 of 2
FS: 1993 Legacy Part Out
Posted: Sat Feb 14, 2009 7:01 am
by kingston
Posted: Sun Feb 15, 2009 12:14 am
by kingston
no one needs some replacement parts?
Posted: Sun Feb 15, 2009 8:43 pm
by kingston
bump!
Posted: Sun Feb 15, 2009 10:39 pm
by Saskatoon Subaru
was this car in running condition at some point?
Posted: Sun Feb 15, 2009 10:44 pm
by PhyrraM
Looks like an auto tranmission.
How complete is the bulkhead harness? Anything cut or missing?
The harness I'm interested in is the one that crosses under the dashboard, over the steering column and punches out through the center of the firewall near the downpipe. In the engine compartment it runs over to the AFM and plugs into the transmission connectors (among other things).
Posted: Sun Feb 15, 2009 11:45 pm
by kingston
It should be very complete. It is an auto car. I can probably take it out mid week if you want it
Posted: Mon Feb 16, 2009 2:05 am
by PhyrraM
Just noticed.... it's most likely not a turbo?
What options did it have concerning the harness? ABS? Cruise?(wheel has it) Sunroof?
Posted: Mon Feb 16, 2009 2:20 am
by jamal
oh sad. it's my old car.
Ciper got most of the way through removing the dash harness and then didn't ever finish taking it out. There shouldn't be anything missing.
It was running fine last July and then spun a rod bearing or 4.
It was a 93 L awd. No sunroof or abs.
Posted: Mon Feb 16, 2009 3:31 am
by kingston
Thanks for chiming in. Going to put that radiator support beam on my SS
Posted: Mon Feb 16, 2009 7:09 am
by Lurch
Do you have the driver's side lap seatbelt?
Posted: Tue Feb 17, 2009 6:57 am
by Zoo Mob
I'll give you $15 shipped for the passenger side side marker light next to the headlights.
ahaan88@yahoo.com
Posted: Tue Feb 17, 2009 7:02 am
by MacNews
What condition are the left and right rear tail-lights?
I have a '92 Legacy and assume they would fit?
Posted: Wed Feb 18, 2009 4:20 am
by kingston
bump...still need the bulk harness or are you looking for a turbo one instead?
Posted: Wed Feb 18, 2009 6:17 am
by PhyrraM
kingston wrote:bump...still need the bulk harness or are you looking for a turbo one instead?
I'm converting a 5-speed swap BACK to an auto. I'm going to study the diagrams. Ideally I need an Auto SS harness. I'm perfectly capable of adding a few circuits, I just have to check out exactly which ones and decide if I want to do the work.
You can PM me a price, it might help me decide one way or the other.
Posted: Thu Feb 19, 2009 4:08 am
by kingston
bumpers
Posted: Sat Feb 28, 2009 8:50 am
by kingston
bump
Posted: Sun Mar 01, 2009 1:43 am
by Aerotech
I need a grey passenger sun visor...
Posted: Sun Mar 01, 2009 2:46 am
by tahiti350
Is it AWD or FWD? I'm looking for FWD REAR suspension forward lateral links for my daughters car...
Posted: Sun Mar 01, 2009 4:23 am
by kingston
it's AWD
Posted: Sun Mar 01, 2009 5:15 am
by tahiti350
Thanks for the quick reply...
Posted: Sun Mar 01, 2009 8:06 am
by Airgne
if you got them. looking for both(left and right) rear side window molding. also looking for the trunk and gas cap release on the drivers floorboard.
Posted: Sun Mar 01, 2009 8:51 am
by cartwheels
Kingston, check your PM's.
Posted: Sun Mar 01, 2009 9:27 am
by kingston
when you say rear side window molding, are you talking about the black rubber that goes around and down the B pillar?
gas cap release i got. the trunk one may be broken. Is that a common problem? My SS broke too.
Posted: Sun Mar 01, 2009 6:09 pm
by Airgne
the side small window. the black plastic trim around the window. its held in by clips and 1 screw. the screw is under the door. you open the rear door and you can see it. can you send a pic ofg your gas cap handle(new to ss), so i can make sure its broke.
Posted: Sun Mar 08, 2009 9:14 pm
by octavian
Hi,
TPS?(THROTLLE POSITION SENSOR)
I live in Romania Europe...Is in working condition?How much will cost me?
