legacycentral bbs

Just like it say's EJ22T minor mods, looking for 65-70 lbs seat psi ordered factory subie 13217AA080 not rite too short & only 52.5 psi can shim them but need to be closer to the psi I actually am looking for

So if any one has ordered them from somewhere or if you got a part # that would be Great I have been looking for two days to no avail .Delta cam "Jonny " told me I needed to shim 'em so any bit of help would be much appreciated

-Thanks Jay

which cams did you get? the stg1 grind or stg2 grind?

I have no idea where to find stiffer ones. Can you even shim the stockers to bump them 10-15lbs??

ps - use better punctuation in your sentences, as I had to read your post a couple times to make sense of it.

I haven't heard of uprated springs for these heads. I'd suggest taking one out, measuring it, and calling up a company who makes springs. They may or may not have something for another application that might work.

Got the springs I was looking for from R& D Spring from California
Very happy with the requested 75.5 lbs of seat psi this is just what the Dr ordered

-jay