Page 1 of 1
FS: 3.90:1 VLSD
Posted: Thu Mar 19, 2009 12:55 am
by 93GCsedan
I have a lsd from my 91 turbo I need to sell. Make me a reasonable offer, and we will see if we can deal.
SOLD
Posted: Thu Mar 19, 2009 1:18 am
by PhyrraM
Miles? With or without the stubshafts?
willing to ship?
Posted: Thu Mar 19, 2009 5:49 am
by 93GCsedan
Yes I am willing to ship. Yes they will come with the stub shafts.
Posted: Thu Mar 19, 2009 5:52 am
by 93GCsedan
Oh I am unsure of the miles as the guy I bought the car from said alot of stuff was swapped. The car was automatic, so the majority of the power wasn't put the the rear.
Posted: Sun Mar 22, 2009 9:11 pm
by gto7419
sent you a message - this still available???
Posted: Tue Mar 24, 2009 4:09 am
by 93GCsedan
pm replied, yes it is still available.
Posted: Fri Oct 02, 2009 8:43 pm
by yazmo
cool i have few question if i have dif 3.90 ratio do i absolutly need lsd 3.90 is there any benifit of going higher ratio?
Posted: Fri Oct 02, 2009 9:09 pm
by yazmo
tomoroow im goi ng in junkyard around here and check if i can find some what do i need to do to remove it! what else need to be take off?
Posted: Fri Oct 02, 2009 9:47 pm
by mike-tracy
yazmo wrote:tomoroow im goi ng in junkyard around here and check if i can find some what do i need to do to remove it! what else need to be take off?
The rear diff needs to be matched (gear ratio-wise) to the transmission. A working vlsd would provide you with better traction on slippery surfaces. To test if it still works? Rotate the axle. If the other side turns the same direction then the vlsd works (with the limited pressure you are putting on it)
As far as going to a higher final drive (eg. 4.111 or 4.44 with a matching transmission, of course!) you should do a search on it's benefits or detractors. Your engine will be in a different rev range than it was before to maintain the same speed.[/b]
Posted: Fri Oct 02, 2009 10:01 pm
by yazmo
thx for the info i also found a tread that show how to swap lsd with picture helpful thx again
Posted: Sun Oct 11, 2009 9:40 pm
by jdmleggy97
pmed