Page 1 of 1
i will need a new 4EAT soon
Posted: Tue Jun 02, 2009 5:10 pm
by greg donovan
the 4EAT in my 95 awd legacy wagon is on its last legs.
aside from another 95 trans what years can i use in this car?
thanks
Posted: Wed Jun 03, 2009 7:16 am
by A1Fiddler
Anything from 90-98 for sure. Not sure about newer ones.
Posted: Wed Jun 03, 2009 4:21 pm
by greg donovan
A1Fiddler wrote:Anything from 90-98 for sure. Not sure about newer ones.
are the ratios all the same?
Posted: Wed Jun 03, 2009 7:54 pm
by wtdash
Ratios for 4EATs:
'90-91 and '95-98 Legacy (not outbacks nor turbos) = 4.11 ratio
'92-94 Legacy, incl. turbo = 3.90
'96-98 Outback and GT (?) = 4.44
I don't think wiring harnesses/TCUs are compatible between the '90-94 and '95-98...as they went OBDII in '95+. They might plug-in but are wired different.
Also, check out Ultimatesubaru.org/forum as they've been over this a 'few' times.
Posted: Thu Jun 04, 2009 3:22 pm
by greg donovan
wtdash wrote:Ratios for 4EATs:
'90-91 and '95-98 Legacy (not outbacks nor turbos) = 4.11 ratio
'92-94 Legacy, incl. turbo = 3.90
'96-98 Outback and GT (?) = 4.44
I don't think wiring harnesses/TCUs are compatible between the '90-94 and '95-98...as they went OBDII in '95+. They might plug-in but are wired different.
Also, check out Ultimatesubaru.org/forum as they've been over this a 'few' times.
thanks, i had a feeling the OBDII was going to become a factor.
Posted: Tue Jun 23, 2009 6:44 pm
by greg donovan
how about a 4EAT from a 98 impreza with a 4.11 ratio?