legacycentral bbs

Posted: **Wed Jun 03, 2009 1:10 am**

I see all these do it yourself FCD some with the fuel cut set hire or just no fuel cut at all. The thing that I'm wondering is if I don't care for safety this or safety that. I mean I do have a boost gauge. Can't I just put a .5-1 Watt 4.3V Zener Diode between the output and ground wires of the MAP sensor?

__________ <-- output wire
###|
###0 <-- Diode
____|______ <-- Ground

# represents space

I was just thinking of connecting the signal wire to output wire with a resistor but that would screw with too much stuff.

Any who thanks for watching.

Posted: **Wed Jun 03, 2009 3:07 pm**

Read through the thread about my electronic FCD -- there's a little discussion in there about this.

Also, check out the [code] [/code] tag:

Code: Select all

it can render text in fixed-width font.

Posted: **Wed Jun 03, 2009 4:15 pm**

Welcome back and thanks. I started to read through yours then the text just started to slowly turn to lines

legacycentral bbs

Am I just trying to make it easy or will it not work?

Am I just trying to make it easy or will it not work?