Page 1 of 1
how muxh HP/TQ gain on stock motor with 3" TBE??
Posted: Thu Jul 02, 2009 12:14 am
by reddragons
i know this isn't an exact science depending on age of car, exhaust installed, etc. ABOUT how much gains does this get on average? Thanks!
Posted: Thu Jul 02, 2009 12:45 am
by magicmike
I'd say it will get louder but your not going to gain much. The turbo exhaust is pretty free flowing for the factory turbo.
Posted: Thu Jul 02, 2009 1:57 am
by 93forestpearl
Tuning in and of itself will net the largest gain. The factory calibration is pretty conservative, which is in the high 10's:1 IIRC. Take a point out of that, with an exhaust and an intercooler and your car will come to life.
Posted: Thu Jul 02, 2009 7:45 am
by A1Fiddler
I noticed quicker spool and more torque. Can't say how much exactly.
Posted: Fri Jul 03, 2009 6:04 pm
by Skruyd
A1Fiddler wrote:I noticed quicker spool and more torque. Can't say how much exactly.
More torque likely due to the fact that it spools faster. So you get it earlier. Not really gaining anything. Just changing the powerband.
Posted: Fri Jul 03, 2009 6:37 pm
by SLODRIVE
More torque earlier is a power gain in every sense, whether or not the peak numbers change. In fact, "more power under the curve" does more to make a car faster in the real world than anything.
Quicker spool=power gain=faster car, assuming everyhing else is equal. And since a larger downpipe/exhaust almost always helps the top end as well, there's usually no sacrifices in power whatsoever.
Posted: Mon Jul 06, 2009 7:59 am
by A1Fiddler
Skruyd wrote:A1Fiddler wrote:I noticed quicker spool and more torque. Can't say how much exactly.
More torque likely due to the fact that it spools faster. So you get it earlier. Not really gaining anything. Just changing the powerband.
Exactly.
Posted: Mon Jul 06, 2009 2:45 pm
by magicmike
I think you are all missing the point here. He said on a STOCK engine. I believe the stock exhaust is plenty big enough to handle the stock engine with stock turbo. If it was a restriction then maybe opening it up would improve performance.
Posted: Mon Jul 06, 2009 7:47 pm
by skid542
^^^ I beg to differ.
The stock exhaust downpipe sucks. It's a plate with a 2.25" hole cut in it with a pipe welded on the back side. This is FAR from optimum. The 2.25" pipe may be 'okay' the rest of way back but it is still more restrictive than a 3" TBE.
In the progress of my car I did a 3" TBE with a simple bellmouth downpipe, rest of the engine system was stock, and I noticed a HUGE difference.
Was it 50chp, probably not, but it did step up and go quicker and harder - most definately. It does make enough of a difference that you can just about max out your MAF with just a 3"TBE and 11psi of boost with the VF11.