legacycentral bbs

i need to get ej22t internals i blew my motor so i am rebuilding the motor

are you looking for stock or after market?

If your looking for used-stock parts, it might take a few sets to find 4 good ones. I brought 8 pistons and 8 rods to my machine shop guy and I still only have 4 good-useable rods and 3 good useable pistons.

I've got what you need. I just took apart an EJ22T motor last week and shipped the two case halves to Blackbart (another user on this forum). I put the crank with the rods still connected into a plastic bag and wrapped it up in paper to protect it. It's sitting in my garage.

I also have the pistons with piston rings still on them and the wrist piston pins and circlips in a box.

I don't know what the going rate is for these parts so make me an offer.

It's heavy so I imagine shipping will be $30-$40.

BTW, the motor was recently purchased from another guy up north in Port Orchard, WA and he says it ran fine when he took it out of his touring wagon. Everything looked good to me when I took it out although I'm not a professional and have no experience with internals.

He said it had about 200K miles on it.

Frank did the internals that were local not go through???

I have stock Ej22T size B pistons if you need them.

I Have a good set of rods and a Crank. I pm'd you on AWDpirates. I am located in Fort Collins.


let me know if you are still looking for a set

I have several sets here.

well i kinda just ran in to some money problems so i will let you know but thanks