legacycentral bbs

Im looking for a good set of head gaskets, better then stock because im running a bit higher comp ratio. can someone tell me where to buy them?


10-22-09
I purchased a full gasket and seal set, it came with stock head gaskets, the multi layer ones. Im going to run 30 Over pistons and was wondering if i could just use them, or if i have to get bigger ones.

the bore is going to be 3.848"
the gaskets are 3.818"
So .030" or .762mm

any of the mls ones will be good. even napa has them.

are they a copper gasket or some material?

mls = multi layer steel.

ALL teh mls head gaskets I have purchased from stores other than subaru direct have been stamped/made by subaru.
they all have the flying wing embossed in them.

I just picked up a Fel-Pro gasket set, and surprisingly they were MLS.

I was expecting the usual kind of gasket......