2in ID, 90 degree aluminum elbow bends---I has dems!
Posted: Tue Feb 02, 2010 1:56 am
I have cast aluminum 90 degree elbow bends in stock that you guys might find useful. Those of you who upgraded to VF, 16G, + 20G turbos might likethis. The problem is, I need to see if it's a perfect fit or not. They are 2in ID and about 2 1/8 OD. Total height is 3in.
Clamping the short cast elbow to a turbo would be a pain, but doable. Some of you may want it welded. The hose to clamp it would be about 1-1.5in long. I don't know if the radius on this is sharp enough to clear the intake manifold. I think it is and will let you know as soon as fitment testing is complete.
Thoughts? These will be priced @ $30 apiece on my new website. I wanted to know if you guys want in on a set after fitment testing.
Clamping the short cast elbow to a turbo would be a pain, but doable. Some of you may want it welded. The hose to clamp it would be about 1-1.5in long. I don't know if the radius on this is sharp enough to clear the intake manifold. I think it is and will let you know as soon as fitment testing is complete.
Thoughts? These will be priced @ $30 apiece on my new website. I wanted to know if you guys want in on a set after fitment testing.