legacycentral bbs

I need this hose because it broke. It felt more like plastic than rubber and it cracked on me. Goes from the crank case ventilation pipe to the underside of the intake. I don't think it's the same as the EJ22T one. It's off the EJ20G motor which doesn't have the F pipe.

It's the missing hose in the picture you can see the nipple it goes on the manifold and the crank case pipe.

i think your best bet is to make a new one from hardware store parts- some braided PVC tubing and an elbow. the pvc tubing is more oil resistant than heater hose and cheaper to boot.

I think I bought new hose for it from autozone but it was so stiff it was going to put too much stress on that plastic pipe and I didn't want it breaking. I'll have to find an elbow then. I'm so sick and tired of all these little PITA setbacks.