legacycentral bbs

I welded my exhaust setup on my TW and just recently put it on my SS and i personally don't think it sticks out that much. Maybe i welded it too short on the TW but who knows. ANyways here's some pics. Let me know what you guys think. I don't think im going to change it. However i am going to remove the 3" Cat that parts of it already came out. eventually

If it was mine I would have the end of the tip about where the beginning of the tip is. But it's not too bad. Should have done a shot from behind.

i'll take a shot, im almost certain it's going to stay like that. at the very least i am going to put a flange or two in because it's all one piece from the turbo back.

cj91legss wrote: i am going to put a flange or two in because it's all one piece from the turbo back.

When you do that, take a couple inches out between the axle back and mid pipe.

I'm gonna have to say it will look better if it was tucked under the bumper some. No offence but this looks kind of ricer style.

Yea it sticks out a bit far IMO

Yeah doesn't look TOO bad from the side but from behind it looks like it's sticking out pretty far.

Maybe if it was angled up and out more...