Page 1 of 1
FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sun Jul 04, 2010 2:32 am
by rocketman
I have two sets of delta cams for 90-94 hydraulic lifter 2.2 heads- both pairs have less then 6k miles on them. I have a shop in Boulder, CO (Wild Westy) that specializes in subaru engine conversions for the vanagon- we installed these cams for two customers who liked the power increase, but not the rough idle,so they were returned to stock.
$100 for each set, plus shipping- I would rather have a local pickup though. They are in the original boxes.
Thanks!
Lucas
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sun Jul 04, 2010 5:37 pm
by beatersubi
Are they for roller or flat tappet-follower heads?
How bad was the idle?
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sun Jul 04, 2010 8:00 pm
by rocketman
They are for dual exhaust port hydraulic lifter (flat tappet) heads only- the idle was slightly rough, but with the engine mounts we use for vanagon conversions, it translated into a lot of vibration in the long VW shift linkage and the exhaust buzzed bit- in a subaru it is not nearly as rough, I have driven old legacy's with these cams and the there is not nearly the vibration as in the vanagon.
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Fri Jul 09, 2010 11:29 pm
by boxerunity
If I get the Leggo I'm looking at I will probably want those. Unfortunately shipping will be a must as I am no where near local.
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sat Jul 10, 2010 3:53 pm
by rocketman
No problem on shipping, let me know if you are interested- they probably won't cost more than 15-20 dollars to ship UPS ground.
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Fri Jul 16, 2010 4:06 pm
by Freerange
PM sent
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sat Jul 17, 2010 5:36 am
by rocketman
Freerange- replied to PM
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sat Jul 24, 2010 12:05 am
by rocketman
One set sold.
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Fri Jul 30, 2010 4:35 am
by rocketman
Sale pending on final set of camshafts.
Re: FS: Delta 'torque grind' camshafts for early n/a 2.2
Posted: Sat Jul 31, 2010 4:20 am
by rocketman
Last set sold, thanks guys!