legacycentral bbs

Hi,
I first sorry for my English. I lost much many and time to find the problem of me engine. When I gave up my friend found out that
it could be pcv valve.
What the simplest way to take out pcv valve?
I thing I have to clean pcv valve .
Could you advise me please?

Thanks a lot

You have located it, correct? If so, you will see that it is just a matter of removing hoses that are connected to it, and putting a wrench on the hex portion of it and unthreading it.

Not sure where you are, but they are not expensive, just get a new one.

Your English is fine.

The pcv valve is threaded into the manifold just to the left of the throttle body, if i remember right it is a 19 mm. Careful taking off the hose though, they tend to get brittle over time and will snap off.

Thanks a lot,
all for your answers. I will try it. I look forward to the moment when I will do it. Do you think its enough to clean it or needs to be replaced
I will inform both, whether I was sucsesfull or not.
thanks both.

They are pretty cheap, so i would just replace it. Whats going on with your car that lead you to the pcv valve?