legacycentral bbs

Hey just wondering if someone could give me some specific details on how to get the ebay 06-07 lip to fit on my 92. I just started to try a little bit ago and it kinda looks like it wouldn't fit. But I know people have it on their 92's. I know you have to cut small chunks out to bend in the sides a little.

So please someone give me a nice good detailed description on how to do it. It would be greatly appreciated.
Thanks.

Bump!

Ask mikeymeyagi, he has one.

Got it on finally.

Looks like you did a fine job sir. I messed mine up somehow and it bends up in the middle. Lame.

looks very clean.

just wondering how you got it to fit?

Easy. Just get a bunch of self tapping screws and bolt it on. Cut out a couple triangles from the corners to help it bend since the sides stick out a lot. Use a heat cut to help it bend nicely. Then trim the ends to fit the bumper.

Kimo, mine started to bend up as well right in the middle, so i made a bracket for it to straighten up again. Now it looks swell.

Thanks guys I just bought a bunch of 1/4 inch and 5/16 bolts, washers, and nuts to use, did you guys use the existing holes? I drilled new holes to get it to fit how I wanted it. Didn't use a single one of the existing holes. I didn't use a heat gun or anything either. Just cut triangles from the bends on each side and the trim the ends to match your bumper. I had 2 friends helping and a lift which helped a lot. Doing this by yourself would be a pain in the ass lol. It isn't perfect, but I'm very happy with it

I used like 20 little self tapping screws, haha. Did it solo. :p

Yup I do everything solo. No lift just a floor jack. None of the existing holes are in the right places to mount it properly to our bumpers.

Could you provide some pictures from under the car? or some install close up's

kimokalihi wrote:Easy. Just get a bunch of self tapping screws and bolt it on. Cut out a couple triangles from the corners to help it bend since the sides stick out a lot. Use a heat cut to help it bend nicely. Then trim the ends to fit the bumper.

any particular type of self tapping screws you went with? 1/2" length would work, right?

1" black self tapping screws and I believe they came with the lip. I bought another lip from a different seller this time I think so we'll see what I get. Should be arriving any day now.

I just used dry wall screws

It works. I used drywall screws to fit my gf's rear lip on her 2000 LX Civic. Worked excellent.

drywall screws work good for everything lol