FS: EJ22t engine
Posted: Fri Apr 29, 2011 7:22 pm
block has eagle rods and ACL race bearings and I put in new o-rings and seals when i built it.
I didn't run it for long because I had another block built with CP pistons and it's been sitting for about a year now.
the only issue with the block is one of the head bolts was snapped off, so it was drilled out and I put in a insert but a shorter bolt is used for the hole, could be redone for the regular length bolt though if someone was motivated enough.
$900
I didn't run it for long because I had another block built with CP pistons and it's been sitting for about a year now.
the only issue with the block is one of the head bolts was snapped off, so it was drilled out and I put in a insert but a shorter bolt is used for the hole, could be redone for the regular length bolt though if someone was motivated enough.
$900