Page 1 of 1
removing 5mt from engine
Posted: Thu Jul 21, 2011 2:01 am
by Falken-18c
ok so when i seperated my 5mt from my motor i just noticed when i used the crow bar it skared up and put lil nudges on the side of the tranny where it seals to the engine in think its not bad and it should seal up but is there and sealnt i could put on it to make sure it seals good ill probly take pics on the week end if im at my car
Re: removing 5mt from engine
Posted: Thu Jul 21, 2011 2:04 am
by Legacy777
You'll be fine. The surfaces don't really do any sealing.
Re: removing 5mt from engine
Posted: Thu Jul 21, 2011 2:09 am
by Falken-18c
ok kool... im always thankfull for the advise
Re: removing 5mt from engine
Posted: Thu Jul 21, 2011 8:31 am
by Florin1
Haha, yeah. no sealing needed. If you peak underneath your car you can actually see your clutch. There's a big 2"x6" slot. That would be a lot of filler. lol
Re: removing 5mt from engine
Posted: Thu Jul 21, 2011 11:26 pm
by Falken-18c
lol kool thanks
Re: removing 5mt from engine
Posted: Fri Jul 22, 2011 12:57 pm
by cj91legss
Florin1 wrote:Haha, yeah. no sealing needed. If you peak underneath your car you can actually see your clutch. There's a big 2"x6" slot. That would be a lot of filler. lol
might have to go to home depot and buy a box of dark grey caulking or get some color matched!!!
