Page 1 of 1
The ultimate Downpipe question.
Posted: Fri Jul 29, 2011 11:29 pm
by CheatingOnMyDub
Does ANYONE make a 3" or 2.5" DP specifically for a first gen Legacy Sport/SS?
Am I going to have to pioneer this marketplace?
I have access to an entire full phase machine shop. 4 Axis CNC mills, welders, benders, even wire edms....whats the word, should I start the prototype?
The ultimate Downpipe question.
Posted: Sat Jul 30, 2011 12:52 am
by Grayguy
Why bother when all the GC and GD ones fit fine?
Re: The ultimate Downpipe question.
Posted: Sat Jul 30, 2011 4:10 am
by cj91legss
i think he's looking for a 3" DP that will bolt on to stock SS exhaust, like some of the cobb GD DPs do. No there isn't a direct bolt on 3" DP.
Re: The ultimate Downpipe question.
Posted: Sat Jul 30, 2011 6:07 pm
by CheatingOnMyDub
Everything I've read so far has said that GC/GD are too long or the length just isn't correct. Also, what about different flanges off the turbo, I could make a DP that has a changeable turbo flange.
Re: The ultimate Downpipe question.
Posted: Sun Jul 31, 2011 9:35 pm
by Apex3
Flanges to the turbo bolt on. IIRC some shorty DPs are the right length but the flange to the midpipe needs to be rotated, I could be wrong though. And the O2 bung is usually at the bottom instead of by the turbo like the stock DP.