legacycentral bbs

I'm about to put my engine back in and last night
I took out the clutch fork on my 94 Legacy to clean
it up and regrease it and I was too dumb to take
pictures of it. Now I cant figure out how the crap
it goes back together. If anyone could tell me how
the crap this goes back together I'd appreciate it.

I dont know why they turned out so huge. Sorry guys!

I'm 95% sure you have it right. That washer fits in the cupped part of the fork as best I remember. You need to tighten the cable down, but the cable is supposed to be a little loose when the clutch is fully engaged, otherwise you'll wear out your throwout bearing prematurely.


Sent from my iPhone using Tapatalk

Well, it's not really sitting where it was before. The bolts, I mean.
At least I dont believe it is. Does anyone have a picture of theirs
I can look at?