legacycentral bbs

Just finishing up a swap in my leggy and am in need of a driveshaft. I just sold my dailly driver last night assuming that one out of a 5mt 98 outback would work and I would finally be back in my Subaru after driving a rubbish 94 Altima for the past 5 months but as it turns out I was wrong.... so if anyone has one laying around that they would be willing to part with shoot me a message! . Also looking for a rear bumper,tailights and garnish for a friends 91 leggy preferably black.






Brendan

Legacy777 said that the front section of the newer driveshaft should bolt to the rear half of your auto drive shaft.

Front is about 1/2 an inch too long . Bump!! I have no vehicle until I find a shaft! Ahhhhh!!

I'm going to try and help out.
I the manual driveshaft is longer in the front only and most of the driveshafts are one piece from 95 up.
I grabbed my driveshaft from a manual parts car I got lucky.
Finally I called around and its cheaper to buy a new one from subaru!

$900 from Subaru. If I had that kind of money sitting about I would get it because I am in serious need of my car but I don't...So I'm going to keep my fingers crossed, keep calling around and hopefully something will pop up. Thanks for your input though!

well its not cheaper in terms of money but its easier to get one that way then find one
good news is its looking like I will have mine out for you on saturday afternoon