legacycentral bbs

i just got done installing my tanabe springs on my new agx's and it seems like the upper perches arent seated properly. theres about a half inch or so gap between the rubber isolator and the upper perch. do i just not have it mounted correctly or will this become a non issue when installed on the car. thanks for the help.

Pictures?

Is this happening on the front and rear perches?

Yeah, any pictures you could post, would be helpful.

its just the rear ones, but ill post pictures this weekend.

Some lowering springs will be loose when the car is not sitting on them with it's weight. For example...my KYB AGX / Ground Control coilover kit is loose and the spring is free floating whenever I jack up the car.

This is a possibility if the lowering springs are short and stiff...not saying this is 100% your issue, just something to consider.

It may be due to the fact that the springs are not meant for the rear tapered spring setup on the 90-91 legacies.

The shocks and springs are both for a cc, same with perches. But yea it maybe the fact that they're lowering springs, I bought compressors, but didn't need to use them.

http://i1354.photobucket.com/albums/q68 ... 88168d.jpg
http://i1354.photobucket.com/albums/q68 ... a9de64.jpg
hope thats clear enough, let me know if i need to take different ones.

Those look normal to me....

ok sweet, i was just worried about the gap there between the isolator and the upper perch but i guess it wont matter when theyre on the car! thanks!

Yeah, that will go away when the spring compresses