Car starts and immediately dies
Posted: Fri Aug 02, 2013 8:30 pm
Might as well ask here while I try to troubleshoot.
It starts up just like normal, but dies immediately, doesn't sputter out or anything just starts up fine and immediately after shuts down, what you would expect from a vacuum line being disconnected. I replaced the MAF with a known good one, made absolutely no difference, neither does unplugging it. I've traced all the vacuum lines and they're all connected, there may be some small leaks but nothing that would keep it from running completely like this. It seems to flood after I try starting it a few times consecutively, it gets more difficult to start, and it makes no difference if I hit the gas to try to keep it running, still dies.
I'm not 100% sure but I think there was a decently loud exhaust pop as I was driving down the freeway, still drove fine after for about 10-15 until I parked, went to move it later and it ran fine, then just all of the sudden died and now here we are.
Any ideas here? It does show a code for MAF, hence why I changed it, but it is possible it's an old code.
EDIT: Fuel pump makes no noise but is getting voltage, I imagine that would mean it's dead correct? Think I found the problem.
It starts up just like normal, but dies immediately, doesn't sputter out or anything just starts up fine and immediately after shuts down, what you would expect from a vacuum line being disconnected. I replaced the MAF with a known good one, made absolutely no difference, neither does unplugging it. I've traced all the vacuum lines and they're all connected, there may be some small leaks but nothing that would keep it from running completely like this. It seems to flood after I try starting it a few times consecutively, it gets more difficult to start, and it makes no difference if I hit the gas to try to keep it running, still dies.
I'm not 100% sure but I think there was a decently loud exhaust pop as I was driving down the freeway, still drove fine after for about 10-15 until I parked, went to move it later and it ran fine, then just all of the sudden died and now here we are.
Any ideas here? It does show a code for MAF, hence why I changed it, but it is possible it's an old code.
EDIT: Fuel pump makes no noise but is getting voltage, I imagine that would mean it's dead correct? Think I found the problem.