Page 1 of 1
EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Thu Jan 02, 2014 11:18 pm
by Baddog
I am going to be building an Ej22T with 5.18" Phase 1 rods w/ 52mm journals, Ej251 crank, have the block machined for the #5 thrust, and the weisco pistons for the 2.35 stroker. Will be running the WRX ECU/Harness/IM/Heads.
Curious on the compression ratio of this engine.
Re: EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Fri Jan 03, 2014 3:41 am
by 86BRATMAN
The ej20 heads are 49cc, if I'm not mistaken the stroker pistons are advertised as 8.5:1 with the 46.6 ej25d heads. Without getting into real calculations it'd be 8.3-8.4:1
Re: EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Tue Jan 07, 2014 4:41 pm
by macipusy
8.3:1 CR sounds right for that setup.
What rods are you using that are Phase 1 with the 52mm journals? I'd be interested in learning about these, since it is a much easier route to the Phase2 crank in Phase1 motor stroker build then the custom piston route I took.
Re: EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Sat Jan 11, 2014 9:18 pm
by Baddog
The rods will be scat 5.18" rods with the 52mm journal. Ej251 crank. Thrust conversion. Weisco pistons
Re: EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Sun Jan 12, 2014 2:45 am
by Baddog
What HG do you use? Ej22T? or Custom cometic?
Re: EJ22T stroker w/ EJ20 WRX heads Comression?
Posted: Sun Jan 12, 2014 8:05 pm
by Mister Anderson
On my hybrid engine I will be running the stock HG thickness for the EJ25D heads, but with a bore size correct for a EJ22T. Cometic makes a decent amount of off the shelf thicknesses for the EJ22T.
Here is my thread that shows the relocation of the thrust bearing;
http://bbs.legacycentral.org/viewtopic.php?f=5&t=52349
If you are in Portland I would take it to Bearing Service Co. They have done it a few times.