legacycentral bbs

Posted: **Tue Feb 11, 2014 3:30 am**

Literally. With my H&R Coilovers these roads (which are terrible!) are literally going to rip the car apart.

Which means I have some work to do as I would prefer this not happen.

I'm going to try and raise the suspension and see if that alleviates some of the problem but I doubt its going to do enough (but who knows, its pretty slammed right now).

If that does not work then I'm going back to a non-coilover setup.

What do you guys think of the Tokico D-Spec struts? Make a good combination with H&R sport springs?

Posted: **Tue Feb 11, 2014 3:56 pm**

After doing some reading it would seem I can switch out the spring on my coilovers as they use a 2.5" ID spring over the bilstein strut. This may be the way to go, with just a softer spring rate.

Posted: **Tue Feb 11, 2014 3:56 pm**

If you go to a strut setup, you have a buyer for your coilovers.

Sent from my iPhone using Tapatalk

Posted: **Tue Feb 11, 2014 4:00 pm**

Sounds good! They're for a GC so they bolt up just fine with no mods.

Posted: **Tue Feb 11, 2014 4:08 pm**

Nice! Already cross drilled for GD struts as well.. Haha. I had STi struts and Tein springs for a bit, they rode great. Struts/springs are way easier on your car, haha.

Sent from my iPhone using Tapatalk

legacycentral bbs

Pittsburgh roads are going to be the death of my car

Pittsburgh roads are going to be the death of my car

Re: Pittsburgh roads are going to be the death of my car

Re: Pittsburgh roads are going to be the death of my car

Re: Pittsburgh roads are going to be the death of my car

Re: Pittsburgh roads are going to be the death of my car