legacycentral bbs

well i been driving my JDM tdo4 and slanty ic for a couple weeks. drives fine pulls hard. just wondering is theres a way to direct the cooler air to the slanty with the stock scoop

That's about as cool as its going to get unless you go front mount.

i figured that much just wondering how i could kinda aim the air to the slanty more

Think it would be to much work. But you could try and get the unslanted WRX intercooler and that might help. Also do you have a turbo blanket and heat shield. If so I wouldn't worry to much unless you just want something to do.

i have a grimmspeed heat sheild. and i was just wondering. i like the slanty because it gives my subie a jdm look. maybe next summer i'll look for a diffrent scoop.

Yea no worries. Some guys use the RS or WRX scopes for looks and a little more air.

You could get the slanty splitter from a GC8, and slot its holes or make a bracket to mount it to our hood. It's not going to be a direct fit by a long shot.

Example:

http://www.ebay.com/itm/400691377803?_t ... EBIDX%3AIT

I run a slanty IC and i noticed a bigger difference when i went with a WRX hood scoop.

How many people seal the area between the TMIC and hood? Directing air through it and not around it should make a big difference.

Any one know if the slanty splitter from an early ver1-2 GC would bolt up? I have one on my car but I have a larger Intercooler so I am only feeding air to half of it.

The holes.dont line up, but you could prob make it up.