legacycentral bbs

Been kicking around the idea of selling my Robtune setup for a while and am finally committed to selling it.

I've got the whole 550 kit. ECU installed in an ej22t case, 4to2 converter, 06 sti injectors installed in N/A fuel rails, JECS green label maf.

When I got the injectors I sent them out to deatschwerks to be cleaned and flow tested. I can't seem to locate the paperwork, this was almost 2 years ago now. They were close to each other flow wise and had a clean bill of health from deatschwerks. Shoot me a PM and include your email address if you'd like a picture of it all, I can't seem to load pictures.

$550 shipped takes it all.

Thanks!
Keats

IIRC were you able to get this setup up and running in your SS? PM'ed you for pics.

Thanks.

are you willing to just sell the ignition adapter?

Nope, never had the setup running in my car. I bought it fresh from Rob and haven't used it. Rebuilt my motor and had some mechanical issues with it. Took it back out and the car has been sitting for the last couple years. I've got a buddy who smashed up his wrx and we're gonna swap in the motor dash and harness. Already have the STi driveline in place and would like to be able to open source tune it myself.

Not looking to part out at this time, thanks.

Wish you were selling a merged harness with this

Merged harness for what? This setup allows us to run an ej20g ecu in our ej22t cars.

i think hes talking about a patch harness with the ignition adapter wired in so you dont have to mess up your cars harness. its what i did when i ran my z4 and what i might do with my 550 tune ecu.

keatsdude wrote:Merged harness for what? This setup allows us to run an ej20g ecu in our ej22t cars.

My car is a 93 n/a and my motor is EJ20k

Would this all still be available?? Super interested

Sent from my Nexus 6P using Tapatalk