Page 1 of 1
WTB (UT): Manual Seat Belts
Posted: Mon Jul 09, 2018 2:21 am
by Benelululu
Looking to buy some Manual Seat Belts. No trim needed, only the complete assembly for the front two seats. Any color except Tan will be good. Shipped to 84010, thanks!
Re: WTB (UT): Manual Seat Belts
Posted: Mon Jul 09, 2018 3:19 am
by Tatsturbo
I used 2nd gen legacy belts. Don't forget the buckle attached to the seats. Slight nodding needed but not bad.
Re: WTB (UT): Manual Seat Belts
Posted: Mon Jul 09, 2018 3:43 am
by Benelululu
I was reading a different forum where someone mention that 2nd gen Legacy seat belts fit into the 1st gen but couldn't get confirmation. Appreciate the info, thank you!
Re: WTB (UT): Manual Seat Belts
Posted: Mon Jul 09, 2018 6:15 am
by Tatsturbo
Yes. There's one spot you need to notch for the "roll" part. You'll see it when you're in there. I went to PnP and got every nut and bolt that pertained to the belt system.
Re: WTB (UT): Manual Seat Belts
Posted: Fri Jul 27, 2018 4:37 pm
by scoobydoo94turbo
I have a set of front seat belts without trim as well as another set with trim, PM me