FS: Western Washington 1991 Sedan turbo swapped
Posted: Sun Jan 26, 2020 7:33 am
So sadly I think the time has come for me to let go of my project car that I have been tinkering with for the last 5ish years. It started as a bone stock L sedan 180k, I drove it home and tore it apart.
It has an ej22t/25d hybrid DOHC motor with a dual ball bearing gtx3076r and a diy rotated kit. Full 3” back to an apexi muffler. Fmic, CNT equal length headers, Cadillac CTSV big brake kit up front with H6 swapped rears. 3.90 turbo legacy trans and a non lsd rear diff. Cusco motor and trans mounts, various poly driveline components with wrx shifter and aftermarket linkage bushings. Flocked dash, quick release steering wheel.
This car was initially built just to run a 550 robtune and I did all the work to convert to a 20g ecu and a 550 tune. I figured I could always go esl if I wanted more. Also wired in COP. I can get the car to crank and dump fuel but it will not spark and I have not been able to get the car to start. I have other projects at this point and do not have the patience to figure this out anymore. There are a lot of parts I’m sure I missed in my list, the car doesn’t run but will roll on to a trailer just fine. This could be a great opportunity for someone smarter than I to get it running or for someone to use as parts (basically a complete car lol). I really DONT want to part this car out, like I said I’m just tired of working on it. If you’re seriously interested shoot me a PM and I can tell you more and answer any questions and maybe work something out.
It has an ej22t/25d hybrid DOHC motor with a dual ball bearing gtx3076r and a diy rotated kit. Full 3” back to an apexi muffler. Fmic, CNT equal length headers, Cadillac CTSV big brake kit up front with H6 swapped rears. 3.90 turbo legacy trans and a non lsd rear diff. Cusco motor and trans mounts, various poly driveline components with wrx shifter and aftermarket linkage bushings. Flocked dash, quick release steering wheel.
This car was initially built just to run a 550 robtune and I did all the work to convert to a 20g ecu and a 550 tune. I figured I could always go esl if I wanted more. Also wired in COP. I can get the car to crank and dump fuel but it will not spark and I have not been able to get the car to start. I have other projects at this point and do not have the patience to figure this out anymore. There are a lot of parts I’m sure I missed in my list, the car doesn’t run but will roll on to a trailer just fine. This could be a great opportunity for someone smarter than I to get it running or for someone to use as parts (basically a complete car lol). I really DONT want to part this car out, like I said I’m just tired of working on it. If you’re seriously interested shoot me a PM and I can tell you more and answer any questions and maybe work something out.