legacycentral bbs

All you get for $25.00 is one piece of 3/8" flat steel with all the downpipe boltholes, "ears" and an oval exhaust hole that is a perfect fit for a slightly squashed piece of 3" mandrel bent tubing. You still need two 90 degree 3"bends from JC Whitney, and a nut welded on to accept your O2 sensor.

I like to wrap the hot side of my turbo and the downpipe at this time.

Just mail a personal check for $25 US to

Bill Robinson
2503 E Illinois
Spokane WA 99207

If anyone else is nterested, please let me know, as I am down to my last couple and I have them plasma cut in batches of ten.

To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com



zZz <http://docs.yahoo.com/info/terms/> .

I just got one from Bill and I install it to my car with 3" custom
made exhaust from Brullen in Toronto, and the result is WOW...
The car pull lot faster then before and the sound is so sweet, man, I
can't drive other car except my Legacy turbo...heheheh
(^_^)... thanks Bill

--- In BC-BFLegacyWorks@y..., "William D. Robinson" <vultureboy@m...>
wrote:
> All you get for $25.00 is one piece of 3/8" flat steel with all the
downpipe boltholes, "ears" and an oval exhaust hole that is a perfect
fit for a slightly squashed piece of 3" mandrel bent tubing. You
still need two 90 degree 3"bends from JC Whitney, and a nut welded on
to accept your O2 sensor.
>
> I like to wrap the hot side of my turbo and the downpipe at this
time.
>
> Just mail a personal check for $25 US to
>
> Bill Robinson
> 2503 E Illinois
> Spokane WA 99207
>
> If anyone else is nterested, please let me know, as I am down to my
last couple and I have them plasma cut in batches of ten.


To unsubscribe from this group, please send an email to:
BC-BFLegacyWorks-unsubscribe@egroups.com