I've decided to use a TD04 setup with my IC. I measured the turbo's inlet and its 2 1/8 exactly. Now for a silicone inlet I plan to use a 90 degree reducer from siliconeintakes.com Do I get a 2 inch, and squeeze it on? Or do I get a 2 1/4 and cramp it on? Since they have no 2 1/8. Also what is the ID of the stock rubber 90 degree inlet goin into the VF11?
Thanks
TD04 inlet
Moderators: Helpinators, Moderators
-
- Fourth Gear
- Posts: 1220
- Joined: Mon Oct 21, 2002 9:53 pm
- Location: Ottawa, Ontario, Canada, Now Sioux Lookout
TD04 inlet
Last edited by LegacyT on Sat Jan 03, 2009 1:35 pm, edited 1 time in total.
1991 Turbo Sedan, Aspen White 5MT, Sold RIP
1994 Turbo Sedan, Crimson Pearl 5MT, from British Columbia-no rust!
1994 Turbo Sedan, Crimson Pearl 5MT, from British Columbia-no rust!
-
- Fifth Gear
- Posts: 8360
- Joined: Mon Nov 06, 2006 3:41 am
- Location: Tenino, WA
I got 2 1/4 and it fits nice.
98 Metro Hatch Daily Driver :)
91 SS EJ20G Engine/Tranny/Diff Swap Build Thread Here
"Your testes are close to your bottom but you still play with them all the time." Jeremy Clarkson
91 SS EJ20G Engine/Tranny/Diff Swap Build Thread Here
"Your testes are close to your bottom but you still play with them all the time." Jeremy Clarkson