legacycentral bbs

***Anyone Interseted at $400???

Hey I'm in Howell, exit 98 off the NJ parkway

No Not yet
been so busy didn't even have time to bump

***Anyone Interseted at $400??? This is my project car but I just don’t have the time any more to work on it. This sucks bec I love the car. So here is the info This is a 93 4WD Wagon 25th Anniversary Edition with 248K miles. Engine is great Transmission is smooth, all gears in great condition. All ...

Aaron Josh I drove the car for a while I don’t hear anything when I drive Only think I can point out is that I think the calipers touch when I break hard, but when I step on gas car doesn’t seem to have any issues. So maybe they really are flexing while breaking Do you think this is a major issue? T...

If it's hitting, you'll hear the noise all the time. Our cars have a fixed caliper, therefore the caliper is always in the same spot and never moves. You could always jack up a corner of the car, put it in neutral and try rotating the wheel. If you can feel a noticeable amount of resistance or can ...

Aaron
Thank you so much for your quick reply
I didn’t notice any issues when I installed the rim
Seemed fine
I’ll hear the squealing every time I break or every time the rim hits the caliper?
Is it safe to drive like this for few days and then look?
Thanx Again

Just installed new 14 inch tires with steel rims The rims where already on the tires and the bolt pattern is the same so I just installed them. How would I know if the caliper is hitting the rim would I hear a contious hitting sound when I drive would breaks lock up? I drove the car didn’t hear much...

What do you think these will fit?
Tirerack says for 15" wheels 195/60 is the max
You think I'll have clearence?
Thanx

Yes definitely used a clutch alignment tool, didn’t take any short cuts there. After playing with it a bit more the shaft slightly turned. But wasn’t easy. Tomorrow I’ll probably install the shifter assembly, this way I’ll know if the transmission is in gear or not. So if the transmission is in neut...

Hello After careful calibration I finally install the transmission. Bottom bolts are in the transmission holes and top bolts are in the engine. However I have no idea if the gears where the transmission meets the pressure plate to clutch to flywheel are lined up correctly. Will the drive shaft easil...

Hello Everyone
I'm about to reinstall my transmission after a clutch change I have a spray of white lithium grease and i was wondering if the the spray or the tub would make a any difference for the idler bearing release fork?
Thanx

Arctic I just looked at a diff site and even a diff manufacture has the same wheel for all models So you are right!! http://www.racepages.com/parts/flywheel/subaru.html I think I'm going to get it. The car has 248K on it so even if I get 50K out of the flywheel I'll be happy. Thanx to everyone on th...

Has any One heard of this Brand? Or better yet used it?

How are these flywheels does any one know?
I can resurface my existing flywheel for $50 or buy this one for $65
Did anyone have a bad experience with these?

eBay link

Thanx In Advance