legacycentral bbs

Does the allen/hex bolt turn CW or CCW?

Does anyone one know how to remove the pulley from the power steering pump on my 00 Legacy? It has a allen/hex head on the front. The reason I have to remove it, is because it is bent, and I am going to replace the seals in the pump. Someone told me that it is welded on from the factory. Is this tru...

Ok, i'll clean all the grounds I see, and pull the plug off the ecu and re-plug. Would it be ok to put die-electric grease on all the electric connections?

Thanks so far for all the input on this......

I located the MAP attached to the intake. I removed it and was somewhat dirty. I then installed it back. There isn't anything sensor connected to the air box. While I was at it, I removed the PVC (I think) and it was really dirty & wasn't rattling. After a good clean, I reinstalled that. I check...

Is the MAF & MAP the same thing? The reason for asking is that my Haynes Manual doesn't say anything about a MAP Sensor until the 2004 year & up. It shows the MAP Sensor for my 2000 Legacy located on the intake manifold. It goes on to say that the MAF is on the throttle body for the turbo ch...

Is this MAF sensor something you clean, or replace? Is there a way to test if it is in fact bad?

The MAF sensor could do that & not show a code? Man, if that would be it!! Btw, I've been saying more saying more than my share of cuss words.......

Some good advice taken and will try these things. One thing, when this starts acting up, the idle is erratic. Goes from around 500 to 1000 rpm. But when put in drive, it is stable until I get to any speed. Also, when in neutral, I rev up the engine a bit, say to around 1600 and quickly release, it s...

Here's one the dealer can't figure. Maybe some of the "Gurus" on here can help. I have the 00 Legacy 4 dr sedan with the 2.5 engine w/auto trans. Here's the problem. There are times that the car will run great, engine runs nice and smooth, trans shifts normal. Then, out of know where, the ...

images or link is not showing up!!

This was the 1st time replaced at 125,000 miles. No, I haven't taken it out to look for "poison" What would be the signs? That's a good idea about going to a pick-u-part and try a used one. So, the one I need will be any "4 Wire O2 sensor"? Would any 4 wire one work from any late...

Here's a how too on the spark plug Non-Fouler or Anti-Fouler I found. http://www.energeticforum.com/renewable-energy/1387-o2-sensor-modification-using-spark-plug-non-foulers.html I found this link after starting this thread. Is there a certain type/number of this O2 simulator I should get? Or does a...

It is a 00 Legacy and both front and rear O2s had been replaced. This mechanic said that some after market O2 sensors can turn bad in a short period of time. As far as using the anti fouler. It is placed in the cat pipe & then the O2 sensor is then screwed into the anti-fouler. This is supposed ...

About 2 months after getting both O2 sensors replaced at Pep Boys, (I know, my bad) the check engine light came on. I went to 2 different places to have the codes checked, & both places said that the "Cats" are bad. Then I went to a friend of a friend to have it checked out, and he tol...

Looking for a good condition, tight, power rack & pinion for my 2000 Legacy L
I think they are the same up to 2004. Can Paypal