legacycentral bbs

Sounds like the voltage regulator (alternator) cutting too much power out of the higher speed range. Hello there. My friend is also experiencing similar situation like redlined and its kinda troublesome for him. You mentioned that the possible cause would be the voltage regulator and I'm wondering ...

I know the oems are a little pricey so I am wondering what you all run for crank and rod bearings non oe. also what are some piston options that arent wiseco? thanks guys, I have to agree with you that the oems are quite expensive. Well, my friend is also looking for a replacement of rod bearing fo...

Whoa! I never thought that replacing the timing belt would cost that much on a shop. Well, my uncle is planning to bring his vehicle on a workshop to have it replace but knowing that it is quite expensive, I think I'll suggest to my uncle of using a subaru timing belt kit instead and have it replace...

Hey there. My friend just recently bought this fuel pump relay to replace the defective ones that he have. You could check that out just in case the dealer is out of stock and you're still looking for it. They have lots of choices that varies on different vehicle. Hope it helps.

Hey there. I found this selection of abs speed sensor you could choose from depending on your vehicle. One of my friend just recently bought from them and he mentioned that they have branded sensors at a good price. You could check that out if you are still in need of the sensor. Hope that helps. :)

Last night I replaced a rear power door lock actuator . I had to use a screwdriver and a hammer to pound out the metal tabs holding the actuator to the mechanism assembly thingy. It seems that the actuator was not built to be replaced, because I had to shear off a bit of plastic in order to slide t...

When you press it, its not suppost to stay pushed in, a light should come on and thats it. Then when you are up to speed push the little lever down hold it for a second then let go of the pedal and it SHOULD start accelerating on its own. I find mine sort of picky just need to figure out the lever ...