Cleaning under the hood....

Heads, valves, pistons, rods, crankshaft, etc...

Moderators: Helpinators, Moderators

Post Reply
Epitaphrox
In Neutral
Posts: 4
Joined: Thu Mar 10, 2005 9:54 am
Location: Nashville, IN
Contact:
Contact Epitaphrox

Cleaning under the hood....

Post by Epitaphrox »

Okay so i'm now probably going to get this 93 legacy.... the plug wires are right on top... and the oil is....well everywhere below the oil fill cap.... so i'm going to take it to the car wash (since its dirty anyway) and spray with the tire/engine spray nozzle.... any objections? and what is that big opening on the right side under the hood about?
Used to say "neener neener neener" now say....

i'll figure something out soon... i hope....
Top
J-MoNeY
Fourth Gear
Posts: 1275
Joined: Sun Nov 16, 2003 9:15 pm
Location: Colorado

Post by J-MoNeY »

Get 2 cans of Gunk and leave your car running. Spray it on while hot, let it sit and then soap the hell out of it. Get real close and blast the shit off. If the car dies, let it sit in the sun and it will be fine.
98 LGT
Top
entirelyturbo
quasi-mod-o
quasi-mod-o
Posts: 6000
Joined: Thu Dec 05, 2002 7:06 pm
Location: Tampa, FL

Post by entirelyturbo »

I say cover as many sensors as you can with plastic bags.

I did the same thing without bags and when I started my car, my CEL came on with 6 codes stored... :shock:
"Der Wahnsinn ist nur eine schmale Brücke/die Ufer sind Vernunft und Trieb"

*Formerly DerFahrer*

@entirelyturbo on social media, including Facebook, Instagram, Twitter, and TikTok
Top
pyropoptrt
In Neutral
Posts: 19
Joined: Sat Jul 26, 2003 7:06 pm
Location: Jackson, MS, USA
Contact:
Contact pyropoptrt

Post by pyropoptrt »

you can use aluminum foil for covering the electronics as well. Easier to mold around an object as well.
Top
Post Reply

Return to “Engine”