Whiteline 20mm rear anti-sway bar & HD mounts

[Legacy777]

I got the bar and HD mounts in today. Wasn't too bad an install. I had the car up on ramps. The bar took a little to get out, but it wasn't impossible. The mount on the passenger side was a little of a bitch to get out. The front bolt is under the filler neck for the gas tank. I used my new ratcheting wrenches. Pretty damn slick.

Took all the old stuff out, put the new mounts on, left them loose until I got everything on. Putting the new bar in was a little more of a pain then getting the old one out, but I figured it out. Attached the bar to the mounts. I still left everything a little loose. I put the new droplinks in. I was a little unsure on how the bar and links went. I put the links on the outside of the bar. That seemed to work. Once I got everything attached loosely, I tightened up the mounts, and then bar. Then snugged the bar to the links, finally links to the lateral links. They were slightly cock-eyed, but I think that's normal. I tightened them down pretty good, but not too tight.

Results, I can definitely tell a difference. There's much less body roll, and I can feel that the rear end is not tweakin around. It remains pretty stiff around turns. The front end likes squeal a little bit, especially on the inside corner.

Overall I like the results a lot. I've gotta play with tire pressure a little. I bumped the front tire pressure up a little bit.

I'm curious as to what a little larger front bar will do. I definitely have more bar to play with in the rear. I'll play with tire pressures and see how the car drives for the next few weeks.

[Legacy777]

Here's some pics

http://www.main.experiencetherave.com:8 ... aybar1.jpg
http://www.main.experiencetherave.com:8 ... aybar2.jpg
http://www.main.experiencetherave.com:8 ... aybar3.jpg
http://www.main.experiencetherave.com:8 ... aybar4.jpg
http://www.main.experiencetherave.com:8 ... aybar5.jpg

[b44jd]

I have a Legacy (Liberty in Aust'a) B4. Put on Whiteline front and rear (adjustable rear) sways, anti-lift kit and an upper front strut brace.

I've also fitted Kings progresive springs which also lowered it about 1".

I'm about to remove the lift kit as I feel the negative, poorer braking, outweighs the positive.

I'll see how I go.

BTW.... all of my gear was fitted by Whiteline themselves.

If you have any questions pls feel free to ask.

Cheers

JD