pistons

[Tleg93]

Do you need a ridge remover to pull the pistons?

[stipro]

No, just watch this video care of Douglas Vincent.

http://www.vincentfurniture.com/photos/ ... onpull.wmv

[douglas vincent]

To make this you need to do this.....

Get a cold rolled steel bar about 3/8 diameter

Stick it in a vice, about 3" in. Bend the fuck out of it and slam it with a sluggo as you go. You want this as tight a bend as possible.

Now take it out of the vice, and slam on the top of the bend some more. You want to bring this bend around 180. You aren't going to be able to do this but this is what you are tyring to achieve.

Now on the straight lenght of it, cut a slot into the curve, and cut the curve off......

Fuck it...

Send me $10 and I will ship you my extra. Then sell it for $10 to the next guy.

Or wait for my video which I will make in the next week or so.