buttons
Moderators: Helpinators, Moderators
-
anthonyle2002
- In Neutral
- Posts: 32
- Joined: Sat Jul 09, 2005 5:55 am
- Location: California, USA
buttons
hello. i have a 1990 Legacy LS AWD and i had a question. theres something wrong with the buttons that operate the fans and vents. if i put it on defrost then it works fine. but when i switch to vent, it doesn't go to the vents. it still goes to the defrost vents but it sounds a bit different. if i leave it like that for a while then it goes into the vents like i want it. any clues anyone?
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
-
IronMonkeyL255
- Fourth Gear
- Posts: 1902
- Joined: Sat Aug 09, 2003 5:02 pm
- Location: Woodruff, SC
Mine did that, too.
I just took it out and re-soldered the faulty joints. I may replace it with a spare '94 unit I have kicking around if it messes up again.
I just took it out and re-soldered the faulty joints. I may replace it with a spare '94 unit I have kicking around if it messes up again.
Disclaimer: If anything I post is inaccurate, please correct me. I do not wish to add to the misinformation floating around on the internet.
That being said, everything I post is accurate to the best of my knowledge.
Rio Red '91 Legacy SS
That being said, everything I post is accurate to the best of my knowledge.
Rio Red '91 Legacy SS