Is there a way I can lower the clutch pedal on my 90 Legacy? It's a cable clutch, so I'm not to sure I can do this. There doesn't seem to be any way to adjust the end play. I'd fabricate something, but I'm afraid the throw or angle of the cabel pull might not work out. If it were a hydrolic clutch it wouldn;t be an issue, but I don;t have a spare pedal set, so if I screw it up it'll be hard to fix.
The problem is that my foot gets stuck on the clutch pedal when left foot braking.
How hard would it be to swap to a hydrolic clutch?
Lower the clutch pedal
Moderators: Helpinators, Moderators
-
sammydafish
- Third Gear
- Posts: 597
- Joined: Mon Dec 20, 2004 2:57 am
- Location: Woodstock, NY
- Contact:
Lower the clutch pedal
- Junior
90L Wagon EJ22E on Toyota CT-26 boost -- Crushed!
95L Wagon on T3/T4 boost :)
www.trdsupra.com [b][url=http://trdsupra.com/library/forsale/]Cheap parts![/url][/b][quote="Imprezive"]alright, I give up, I'm going to NASIOC...[/quote]
90L Wagon EJ22E on Toyota CT-26 boost -- Crushed!
95L Wagon on T3/T4 boost :)
www.trdsupra.com [b][url=http://trdsupra.com/library/forsale/]Cheap parts![/url][/b][quote="Imprezive"]alright, I give up, I'm going to NASIOC...[/quote]
You can adjust the height by adjusting the clutch cruise sensor position. That sets the pedal height. If you do this though, you will need to back off the adjustment at the clutch fork side on both the clutch cable & probably hill holder....
Josh
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm
surrealmirage.com/subaru
1990 Legacy (AWD, 6MT, & EJ22T Swap)
2020 Outback Limted XT
If you need to get a hold of me please email me rather then pm