wiring my engine into my impreza is going smooth, i am not sure what a few things mean.
TI monitor...? on the leg but not in my impreza
Jurisdiction ID...? same thing
select monitor Tx, Rx, whats the difference? how can i tell on my impreza diagram since its not labeled which is which?
thanks for your help man, and im SOO glad i have that diagram to work from!
Q about VRG's ECU pinouts!
Moderators: Helpinators, Moderators
-
vrg3
- Vikash
- Posts: 12517
- Joined: Sun Nov 03, 2002 2:13 am
- Location: USA, OH, Cleveland (sometimes visiting DC though)
- Contact:
Ignore the TI monitor and jurisdisction ID.
Unless you want your ECU to be in California mode; if you do, ground the jurisdiction ID pin.
As for the Select Monitor connections, you'll need to use a continuity tester to check which is which on your stock harness.
http://www.graphics.cornell.edu/~v/bcbfscan/
The one that shows continuity to pin 2 of the yellow diagnostic connector should be connected to B56 pin 8.
The one that shows continuity to pin 3 goes to B56 pin 7.
Note that you only need to bother with this if you plan on using a Subaru Select Monitor on the car. If you only want to use my scantool, you may as well simply wire a DB25 connector right in.
Unless you want your ECU to be in California mode; if you do, ground the jurisdiction ID pin.
As for the Select Monitor connections, you'll need to use a continuity tester to check which is which on your stock harness.
http://www.graphics.cornell.edu/~v/bcbfscan/
The one that shows continuity to pin 2 of the yellow diagnostic connector should be connected to B56 pin 8.
The one that shows continuity to pin 3 goes to B56 pin 7.
Note that you only need to bother with this if you plan on using a Subaru Select Monitor on the car. If you only want to use my scantool, you may as well simply wire a DB25 connector right in.
"Just reading vrg3's convoluted, information-packed posts made me feel better all over again." -- subyluvr2212
-
ultrasonic
- Third Gear
- Posts: 654
- Joined: Sat Dec 20, 2003 6:34 am