WANTED:EJ18 CARB INTAKE MANIFOLD

monstaru · Post by **monstaru** » Tue Apr 25, 2006 1:19 am

title says it all.i would love to get my hands on one of these.i am usually over on the USMB but am trying to cover all of my options. thanks guys,cheers,brian

206er · Post by **206er** » Tue Apr 25, 2006 1:43 am

are you gonna set up a distributor too or use the stock ignition?

monstaru · Post by **monstaru** » Tue Apr 25, 2006 2:02 am

i have a disty setup.thanks,brian

legacymax · Post by **legacymax** » Tue Apr 25, 2006 5:07 am

When did they use an carb with an EJ18?
-max

Post by **DLC** » Tue Apr 25, 2006 6:16 pm

Outside of the US, in the Legacy and Impreza models, usually in Europe.

legacymax · Post by **legacymax** » Tue Apr 25, 2006 7:14 pm

ok.
-max

EJ22_SLO · Post by **EJ22_SLO** » Tue Apr 25, 2006 9:34 pm

Here in Europe we have "carbed" (monopoint injection) EJ18, Legacy 1st and 2nd gen. In Leone (EA82) we have two types of engine - one pure carb, and the other one is monopoint injection...

If you're looking for EJ18 intake manifold like the bottom one on pics below (upper is from EJ22 N/A)... perhaps i could find one.

monstaru · Post by **monstaru** » Tue Apr 25, 2006 10:45 pm

as long as it will bolt up to an ej22 i will take it.of course i would compensate you as well.what would you take for one and shipping would be to

spokane,washington 99202 USA

thanks, brian

EJ22_SLO · Post by **EJ22_SLO** » Tue Apr 25, 2006 11:04 pm

Ej18 - at the picture wont bolt on Ej22 engine;
problem no1: you can see Ej18 has integrated "water pipe" (EJ22 engine has separated water line),
problem no2: i can tell you it has much smaller diameter.... won't fit...
problem no3: IAC valve, vacuum...

i can take some more comparation pictures and measurements if you want... but i'm 98% it wont fit. at least not without modifications...

monstaru · Post by **monstaru** » Tue Apr 25, 2006 11:24 pm

the water jacket can be taken care of.the smaller diameter pipe is not really a concern.i like to fabricate things.also,from what i hear,it should be a direct bolt up as far as where the heads meet the manifold.thanks, brian

do you have a picture of the bottom?i would love to see it.thanks again,brian

monstaru · Post by **monstaru** » Tue May 02, 2006 1:14 pm

bump.........a monopoint or carb manifold is suitable now.

EJ22_SLO · Post by **EJ22_SLO** » Wed May 03, 2006 8:13 pm

sorry -this weekend was hell...

bottom side of EJ18 intake maniforld; the gasket is from EJ22 engine - to compare and check the holes.... scale is in metric - cm; there's flap missing on pictures - it was removed it during cleaning; EJ18 ECU is also available.

legacycentral bbs

A forum for 89-94 BC-BF(BJ) Legacy Owners and Fans

WANTED:EJ18 CARB INTAKE MANIFOLD

WANTED:EJ18 CARB INTAKE MANIFOLD