hey all,
looks like my raise at my current employer is going to take longer than initially expected so this stuff has to go.
All items are OBO so if you have a resonable offer ( please dont lowball )
Stock WRX TD04 Turbos (2) - (Pending Sale)
Arias forged pistons - ej25 block ( not sti ) drops CR to 8:1 , would work in sti block if you machine .049 off the top - $325
Haltech e6x with flying lead harness , 3 bar map sensor, air temp sensor, and a mazda ignitor - $875
ej25 sti block low miles, ring lands cracked on one piston minor scoring on the one cyl wall, could be cleaned up with a simple hone , was planning on just cleaning it up and putting a new piston and rings in the one cyl. - $850
also have some 5.0 parts but I doubt anyone here is interested, a inj manifold and big t-body and MAF, if you are interested in those pm me.
thanks guys.
** Located in Nor-Cal ( sacto ) **
Cleaning out the garage, project has changed directions
Moderators: Helpinators2, Moderators
Forum rules
Please see the NEW Parts Shed Rules before posting: http://www.bbs.legacycentral.org/viewto ... 15&t=55814
Sales of parts and parting cars only. Complete or parted car posts should be made in Car Lot: http://www.bbs.legacycentral.org/viewforum.php?f=32
Please see the NEW Parts Shed Rules before posting: http://www.bbs.legacycentral.org/viewto ... 15&t=55814
Sales of parts and parting cars only. Complete or parted car posts should be made in Car Lot: http://www.bbs.legacycentral.org/viewforum.php?f=32
Cleaning out the garage, project has changed directions
Last edited by drftsub on Thu Aug 24, 2006 10:42 pm, edited 2 times in total.
all these parts werent from the same project 
but the subie parts were going to build a hellofa drift legacy . RIght now its running on the mostly stock ej22, I am going to run a ball bearing turbo and custom build some manifolds for it I think still and of course my 20g heads to go on, but the big stuff needs to go.
THe mustang stuff is left over from a cobra kit car project I did for someone.
but the subie parts were going to build a hellofa drift legacy . RIght now its running on the mostly stock ej22, I am going to run a ball bearing turbo and custom build some manifolds for it I think still and of course my 20g heads to go on, but the big stuff needs to go.
THe mustang stuff is left over from a cobra kit car project I did for someone.
...::Slide your ride::...
[url=http://www.driftsub.com/]^driftsub^[/url]
[url=http://www.sloganizer.net/en/]>I wish i was a driftsub<[/url]
[url=http://www.driftsub.com/]^driftsub^[/url]
[url=http://www.sloganizer.net/en/]>I wish i was a driftsub<[/url]