what control arms fit?

[bmxkelowna]

i need a front right control arm, sway bar end link and tie rod.
what subarus can i get these off of?

i saw this online
BAJA 03-04
FORESTER 98-00
IMPREZA 93-01
LEGACY 90-04

is that right? can i use a control arm from any one of those?
what about the end link and tie rod?

[Imprezive]

just buy a brand new one for your car. I know it will be more expensive but why run the rist of getting another bent control arm.

[n2x4]

When I bent my control arm, I bought a control arm w/ balljoint and endlink from the junk yard for 30 bucks. It was off a 96 Legacy. Personally, I wouldn't get a junkyard tie rod, those are cheap enough, but the list you had seems correct. I don't think a new control arm is needed, too expensive.

[mr soul]

That list is correct, you could by 4 or 5 used before you get to the cost of 1 new one.

I have this if you need it, but local resources should too.


Keith

[jamal]

Your list sounds about right. There's not much reason to spend the extra money other than for the fresh bushings. It's not like a new arm will be any less likely to get bent if you run into something else.

My used control arm from awhile back was $35 shipped. My balljoint and wheel bearing also got trashed so make sure they're alright as well. My used steering knuckle and bearing ($45) lasted a year and I just had to have the bearing and hub replaced.