Heads, valves, pistons, rods, crankshaft, etc...
Moderators: Helpinators , Moderators
SergeyZ
In Neutral
Posts: 34 Joined: Mon Apr 09, 2007 11:42 pm
Post
by SergeyZ Thu Apr 12, 2007 6:40 am
I know the head size is 22mm for the crank pulley bolt, but what about the thread itself? I need to rethread the crank. I am thinking it is an M14 x 2?
Last edited by
SergeyZ on Tue Apr 17, 2007 9:57 pm, edited 1 time in total.
Subaru for Life
First Gear
Posts: 87 Joined: Fri May 12, 2006 6:55 pmLocation: Ft. Lauderdale, S. Florida
Post
by Subaru for Life Thu Apr 12, 2007 7:35 pm
It's M14 x 1.5
Subaru_for_Life
SergeyZ
In Neutral
Posts: 34 Joined: Mon Apr 09, 2007 11:42 pm
Post
by SergeyZ Thu Apr 12, 2007 10:25 pm
Thanks man!
SergeyZ
In Neutral
Posts: 34 Joined: Mon Apr 09, 2007 11:42 pm
Post
by SergeyZ Tue Apr 17, 2007 8:28 pm
M14 x 1.5 is too big! I just measured the threads of the crank bolt and it came out to 12.8mm.
I cant figure this out. It is not an M12 bolt, cause then it would be 12mm instead of 12.8. And an M14 is too big!
An M14 tap doesnt even slide into the crank opening.
